-
The SCR in Figure 1 below requires a 3 V trigger. Using Multsim, design a system by which the gears are shifted when a CdS photocell resistance drops below 4k.
Figure 1
- Using Multisim, design a system by which a control signal of 4 to 20 mA is converted into a force of 200 to 1000N. Use a pneumatic actuator and specify the required diaphragm area if the pressure output is to be in the range of 20 to 100kPa. An I/P converter is available that converts 0 to 5 V into 20 to 100 kPa. A block diagraph of the system is shown below. (Hint: Use a differential amplifier. You are only designing the circuit to interface into the I/P below)
The post help 7001203 2 appeared first on BlueOrigin EssayWriters.
Plagiarism Free Assignment Help
Expert Help With This Assignment — On Your Terms
✓ Native UK, USA & Australia writers
✓ Deadline from 3 hours
✓ 100% Plagiarism-Free — Turnitin included
✓ Unlimited free revisions
✓ Free to submit — compare quotes